WHMIS Training Does Not Cover Your Truck
A plumber finishes a WHMIS refresher, signs the sheet, and drives away with an acetylene cylinder, an oxygen cylinder, a jerrycan of gasoline for the generator and a case of solvent in the back of the truck. Every one of those is a dangerous good in transport, and the WHMIS training just completed has nothing to say about them.
WHMIS and the Transportation of Dangerous Goods Regulations are two different laws covering two different moments. WHMIS governs hazardous products in the workplace and sits under occupational health and safety legislation, which is mostly provincial. TDG governs those same products once they are on a road, and it is federal, administered by Transport Canada under the Transportation of Dangerous Goods Act, 1992, and it applies in every province and territory. Completing one does not satisfy the other, and the certificate from one is not evidence of the other.
Most trades operate on an informal assumption that TDG is a trucking company problem. It is not. It is a problem for anyone whose vehicle carries fuel, gas cylinders, solvents, adhesives, pool chemicals, refrigerants or paint between a supplier, a shop and a job site, which is most of the trades in this country.
Transport Canada's own advice is to assume you need training
Training sits in Part 6 of the TDG Regulations, and the guidance from Transport Canada is unusually direct about how to approach the question. Its dangerous goods frequently asked questions advise that you should always assume you need training. Training is not required only where you are operating inside an exemption, and most exemptions are in Part 1 of the regulations, with some further special provisions in Schedule 2.
That framing is the opposite of how the question usually gets asked on a job site, where the starting assumption is that an exemption probably applies and somebody will say so if it does not. The regulation starts from the other end: you are covered unless you can point to the specific provision that releases you, and you have to know which one it is.
Anyone who handles, offers for transport, or transports dangerous goods needs the training. Note that handling and offering for transport are separate triggers from driving. The person who fills a cylinder, or who loads one into a vehicle, is inside the regulation even if they never leave the yard.
Your TDG certificate is issued by your employer, and it does not travel with you
This is the detail that surprises people who have held a card for years. A TDG training certificate is issued by the employer once the employee has received adequate training. A self-employed person issues their own. Certificates are not transferable between companies.
So the plastic card from a one-day course is not, by itself, the thing the regulation asks for. The course is how the training requirement gets met; the certificate is the employer's attestation that this particular employee has been adequately trained for the work that employer has them doing. Change employers and the new employer has to satisfy itself and issue its own, even if the course content was identical.
There is no prescribed format for the certificate, but it has to contain the information required by Section 6.3 of the regulations. That means a document that simply says a name and a date is not sufficient, and a laminated card with a provider's logo may or may not carry what is required. Worth checking what your own certificates actually say.
Two practical consequences. First, if you hire a worker who arrives with a TDG card, you still owe them a certificate of your own, which is the same structural point made in our article on why paying an agency premium does not transfer the duty: training that happened elsewhere does not discharge your obligation. Second, an untrained worker may work under the direct supervision of a trained one, which is a narrower allowance than it sounds and is not a substitute for training the people who regularly do the work.
The 150 kilograms includes the steel
The exemption almost every trade relies on, usually without knowing its number, is the 150 kg gross mass exemption in Section 1.15. When all of its conditions are met, CCOHS describes shippers as fully exempt from the TDG Regulations, which is why so much trade work proceeds without anyone thinking about Transport Canada at all.
The trap is in the words "gross mass." Gross mass is the weight of the means of containment plus all of its contents, for every dangerous good being carried together. The cylinder counts. The jerrycan counts. The steel is most of the weight.

An empty 33 pound propane cylinder is roughly 7 or 8 kg of steel before any propane goes in. A full 100 pound cylinder runs well past 70 kg all in. An oxygen and acetylene pair with a jerrycan of gasoline and a few pails of solvent adds up quickly, and the 150 kg cap applies to all of it added together, not to each item. CCOHS makes the point explicitly: a mixed load of welding gases plus a fuel jerrycan counts toward one total.
Which means the honest answer to "are we under 150 kg?" is usually "nobody has weighed it." That is a different answer from "yes," and it is the one that matters if an inspector asks. The way to settle it is to add up the tare weights stamped on the cylinders plus the contents plus the containers, once, for the standard load that truck carries, and write the number down.
The conditions people miss
Gross mass is only the first condition. The exemption is a package, and failing any single element takes the whole thing away.
The goods have to be in a quantity and concentration sold to the general public at retail. Trade-strength material bought in commercial sizes from a supply house is not automatically retail-quantity goods, and this is where a lot of assumed coverage quietly fails.
Containers have to weigh 30 kg or less, with gases treated separately. Flammable gases such as propane and acetylene are limited to a 46 litre cylinder capacity, and the cylinder itself still has to meet the containment requirements in Part 5 of the regulations. So the exemption does not license you to carry any cylinder you happen to own; the cylinder has to be a compliant, in-date cylinder, which is covered further in our article on compressed gas cylinders and why a cylinder is not a roller.
The transport has to be by a user or purchaser of the goods, or by a retailer to or from a user or purchaser. Carriers who are not the retailer cannot use this exemption at all. A contractor hauling cylinders on behalf of a customer, or a courier moving them for a fee, is outside it.
Containment has to be strong and secure enough to prevent a release that could endanger public safety, and designed not to leak under normal conditions of transport. Secured upright, in other words, not rolling loose in a box full of tools.
And the exemption cannot be combined with the 500 kg exemption in Section 1.16, with the agricultural exemptions in Sections 1.21 or 1.22, or with a shipment that requires a shipping document. Subsection 1.15(2) also lists categories of goods that cannot move under it at all, including forbidden goods, anything requiring an Emergency Response Assistance Plan, temperature-controlled goods, most Class 1 explosives, and certain Class 2, 4, 5.2, 6.1, 6.2 and 7 materials.
FOR CREWS WHO WORK OUT OF A TRUCK
Certified footwear for service work that moves between yard, road and site. Workman Industrial stocks CSA-certified safety footwear, with guides for delivery drivers and HVAC technicians.
Exempt is not unregulated
CCOHS puts this in one line that deserves to be read twice: exempted does not mean not regulated. Any remaining or additional requirements still apply.
An exemption lifts named parts of the TDG Regulations when its conditions are met. It does not lift the rest of the legal landscape. Provincial occupational health and safety law still governs how those cylinders are stored, handled and secured at the workplace. Fire code provisions still apply to quantities kept on site. Vehicle and highway legislation still applies to the load. And the general duty in the due diligence standard does not care which federal part you were exempt from.
There is also a reporting dimension worth planning for. Where an exemption lifts the accidental release reporting obligations in the regulations, it does not make a leaking acetylene cylinder in a parking lot somebody else's problem. That is still an emergency, and it belongs in your emergency preparedness arrangements and, afterwards, in the investigation and reporting process you run for anything else.
The safety data sheet may not tell you
Here is the gap that catches careful people. The instinct, when you want to know whether something is a dangerous good, is to pull the safety data sheet and look at Section 14, which is the transport information section.
It may be blank, or absent, or wrong. CCOHS notes that Section 14 may not list transport information, because transport information is not mandatory under WHMIS. The SDS is a WHMIS instrument. It is built to tell you about workplace hazards, handling, exposure and first aid, and the transport section is a courtesy rather than a requirement.
So an SDS with nothing useful in Section 14 is not evidence that a product is unregulated for transport. If you are not sure whether something is a dangerous good, CCOHS advises asking the manufacturer or supplier for proof of classification. That is a specific request: the shipping name, the class, the UN number and the packing group, in writing, from the party who knows.
This is worth reading alongside our article on the WHMIS amendments and what changed on safety data sheets, because the two systems use different classification logic and a product's WHMIS classification does not map onto a TDG class.
Limited quantities are a different exemption with its own marks
The other provision trades meet without naming it is the limited quantity exemption in Section 1.17, which covers small amounts of goods the general public normally has access to, such as aerosols and small cans of paint.
Whether a product can move this way is decided by Column 6(a) of Schedule 1 to the regulations. A limited quantity index of zero means the goods cannot be shipped as a limited quantity at all. Where the conditions are met, shipping documents, labels, placards and standardized packaging requirements may be lifted, but each outer container must weigh 30 kg or less and must display the international limited quantity mark, and inner container limits are set by mass or volume in that same column.
The mark is the part that gets skipped. A limited quantity shipment without the mark is not a limited quantity shipment; it is an unmarked shipment of dangerous goods. The exemption buys you relief from the heavier requirements in exchange for a specific label, and the trade only works if you apply the label.
TDG applies to people, not just companies
One more thing that surprises most workers. TDG is not limited to businesses. CCOHS states plainly that it also applies to members of the public transporting dangerous goods for personal use, and gives gasoline in a jerrycan, oxygen cylinders and propane cylinders as examples.
The reason nobody notices is the 150 kg exemption, which is broad enough to cover a barbecue bottle and a jerrycan on a weekend. That is the exemption doing its job. It also means the line between a personal errand and a work trip is not where the regulation sits, and a tradesperson filling the truck on the way to a job does not become exempt because the stop was personal.
What to settle before the truck leaves the yard
Write down what the vehicle actually carries
List the dangerous goods that travel in each vehicle as a matter of routine, with the container type and size. Most companies have never done this and are surprised by the list. It is also the input to every other decision below.
Add up the gross mass once
Tare weight plus contents plus containers, for all dangerous goods together, for the standard load. If the number is close to 150 kg, treat it as over, because the load changes and nobody reweighs it on a Tuesday.
Identify the exemption by section number, or train
If you are relying on an exemption, know which one and confirm every condition, including the retail-quantity requirement and the user or purchaser requirement that quietly excludes hauling for a customer. If you cannot satisfy all of them, the answer is training under Part 6, shipping documents and safety marks, not a smaller guess.
Issue proper certificates
Confirm your certificates contain what Section 6.3 requires, that they are issued by your company rather than relied upon from a previous employer, and that new hires get their own. This belongs in the same orientation process as everything in our piece on new and young worker orientation.
Secure the load properly
Cylinders upright and restrained, valves protected, nothing stored in an enclosed cab where a leak collects. Cylinders and fuel in a closed vehicle with people in it is the arrangement behind a lot of the incidents in this area, and it also raises the hazards covered in our articles on carbon monoxide and on the vehicle as a workplace.
Sort it out on multi-employer sites
Where several companies bring materials to one site, settle who is transporting what and who holds which certificates, because prime contractor obligations do not resolve federal transport duties, and the deliveries arriving at your gate are somebody's TDG shipment. Put the vehicle load check into the regular site inspection program rather than treating it as a one-time audit.
Frequently asked questions
Do I need TDG training to carry propane and acetylene in my work truck?
Possibly not, if you are genuinely inside an exemption such as the 150 kg gross mass exemption in Section 1.15 and meet every one of its conditions. Transport Canada's guidance is to assume you need training unless you can identify the specific exemption that applies. Because gross mass includes the weight of the cylinders themselves and the cap covers all dangerous goods on the vehicle together, many trade loads are closer to the limit than expected.
Does WHMIS training cover transportation of dangerous goods?
No. They are separate legal regimes. WHMIS covers hazardous products in the workplace under occupational health and safety legislation, which is mostly provincial. TDG covers the same products in transport under federal legislation administered by Transport Canada. A WHMIS certificate is not evidence of TDG training, and a product's WHMIS classification does not map onto a TDG class.
Who issues a TDG training certificate in Canada?
The employer issues it, once satisfied the employee has received adequate training. Self-employed people issue their own. There is no prescribed format, but the certificate must contain the information required by Section 6.3 of the TDG Regulations. A course completion card from a training provider is how the training is obtained, not the certificate the regulation requires on its own.
Is my TDG certificate valid if I change employers?
No. TDG training certificates are not transferable between companies. A new employer has to satisfy itself that the worker is adequately trained for the work it assigns and issue its own certificate, even where the original course content was the same. An untrained worker may work under the direct supervision of a trained one, which is not a substitute for training people who do the work regularly.
What does the 150 kg gross mass exemption actually cover?
When every condition is met it exempts the shipment from the TDG Regulations, including documentation, safety marks, training and release reporting. The conditions include a total gross mass of 150 kg or less for all dangerous goods together, containers of 30 kg or less with gases treated separately, retail quantities and concentrations, transport by the user or purchaser or by a retailer to or from them, leak-resistant containment, and a 46 litre cylinder capacity cap on flammable gases such as propane and acetylene. It cannot be combined with the 500 kg or agricultural exemptions.
Does TDG apply to individuals, not just companies?
Yes. CCOHS confirms that TDG applies to members of the public transporting dangerous goods for personal use, such as gasoline in a jerrycan or a propane cylinder for a barbecue. Most people never notice because the 150 kg gross mass exemption covers ordinary personal quantities, but the regulation itself is not limited to commercial operations.
Find your exemption, or do the training
There are only two defensible positions on this subject. Either you can name the exemption you are relying on and confirm each of its conditions for the load that actually travels in your vehicles, or your people are trained under Part 6 and hold certificates your company issued. The common third position, which is that TDG is for trucking companies and somebody would have mentioned it, is not one of them.
The cost of settling it is an afternoon: list the goods, weigh the standard load, read Section 1.15 against it, and decide. The cost of not settling it arrives as a roadside inspection or, far worse, as a cylinder venting in a closed van.
Workman Industrial does not sell TDG training, placards, shipping documents, dangerous goods packaging or cylinders, and we are not the people to classify a product for you. Training comes from accredited providers, classification comes from your supplier or manufacturer in writing, and the regulation comes from Transport Canada. What we supply is the footwear and workwear the crew wears between the yard, the road and the site.
KITTING OUT A SERVICE CREW
Certified boots, hi-vis apparel for roadside and yard work, and the CSA work boot guide if you are specifying footwear for a fleet. If your crews handle solvents and coatings, our article on selecting chemical resistant gloves covers the other place product data gets misread.